11 June 2013 Methods for joint optimization of mask and design targets for improving lithographic process window
Author Affiliations +
Abstract
Low-k 1 lithography results in features that suffer from poor lithographic yield in the presence of process variation. The problem is especially pronounced for lower-level metals used for local routing, where bi-directionality and tight pitches give rise to lithography unfriendly layout patterns. However, there exists inherent unutilized flexibility in design shapes, e.g., one can modify such wires without significantly affecting design behavior. We develop two different techniques to simultaneously modify mask and design shapes during optical proximity correction (OPC) to improve lithographic yield of low-level metal layers. The methods utilize image slope information, which is available during OPC image simulations at no extra cost, as a measure of lithographic process window. We first propose a method that identifies fragments with low normalized image log slope (NILS) and then use this NILS information to guide dynamic target modification between iterations of OPC. The method uses a pre-characterized lookup table to assign a different magnitude of local target correction to different NILS bins. Next we develop an optimization flow where we derive a cost function that maximizes both contour fidelity and robustness to drive our simultaneous mask and target optimization (SMATO) method. We develop analytical equations to predict the cost for a given mask and target modification and use a fast algorithm to minimize this cost function to obtain an optimal mask and target solution. Our experiments on sample 1× (M1) layouts show that the use of SMATO reduces the process manufacturability index (PMI) by 15.4% compared with OPC, which further leads to 69% reduction in the number of layout hotspots. Additionally, such improvement is obtained at low average runtime overhead (5.5%). Compared with process window optical proximity correction (PWOPC), we observe 4.6% improvement in PMI at large (2.6× ) improvement in runtime.
© 2013 Society of Photo-Optical Instrumentation Engineers (SPIE)
Shayak Banerjee, Shayak Banerjee, Kanak B. Agarwal, Kanak B. Agarwal, Michael Orshansky, Michael Orshansky, } "Methods for joint optimization of mask and design targets for improving lithographic process window," Journal of Micro/Nanolithography, MEMS, and MOEMS 12(2), 023014 (11 June 2013). https://doi.org/10.1117/1.JMM.12.2.023014 . Submission:
JOURNAL ARTICLE
16 PAGES


SHARE
Back to Top