20 August 2013 Defect source analysis of directed self-assembly process
Author Affiliations +
As design rule shrinks, it is essential that the capability to detect smaller and smaller defects should improve. There is considerable effort going on in the industry to enhance immersion lithography using directed self-assembly (DSA) for the 14-nm design node and below. While the process feasibility is demonstrated with DSA, material issues as well as process control requirements are not fully characterized. The chemical epitaxy process is currently the most-preferred process option for frequency multiplication, and it involves new materials at extremely small thicknesses. The image contrast of the lamellar line/space pattern at such small layer thicknesses is a new challenge for optical inspection tools. The study focuses on capability of optical inspection systems to capture DSA unique defects such as dislocations and disclination clusters over the system and wafer noise. The study is also extended to investigate wafer-level data at multiple process steps and to determine the contribution from each process step and materials using defect source analysis methodology. The added defect pareto and spatial distributions of added defects at each process step are discussed.
© 2013 Society of Photo-Optical Instrumentation Engineers (SPIE)
Paulina Rincon Delgadillo, Paulina Rincon Delgadillo, Mayur Suri, Mayur Suri, Stephane Durant, Stephane Durant, Andrew J. Cross, Andrew J. Cross, Venkat R. Nagaswami, Venkat R. Nagaswami, Dieter Van den Heuvel, Dieter Van den Heuvel, Roel Gronheid, Roel Gronheid, Paul F. Nealey, Paul F. Nealey, } "Defect source analysis of directed self-assembly process," Journal of Micro/Nanolithography, MEMS, and MOEMS 12(3), 031112 (20 August 2013). https://doi.org/10.1117/1.JMM.12.3.031112 . Submission:

Back to Top