5 February 2014 Comparative study of various release methods for gold surface micromachining
Author Affiliations +
A comparison of dry and wet release methods for surface micromachining of metallic structures, such as RF MEMS switches, test structures, bridges, and cantilevers is presented. The dry release process is optimized by varying the concentration of O 2 and CF 4 plasma and RF power. The plasma ashing of the sacrificial layer typically results in damage to metallic structures or stress-related deformation due to rise in temperature (<80°C ). A wet release process using critical point drying (CPD) has been investigated to realize gold-electroplated structures with reduced residual stress. The CPD, being a low-temperature (31.1°C) process, is more suitable for compliant structures without any deformation.
© 2014 Society of Photo-Optical Instrumentation Engineers (SPIE)
Akshdeep Sharma, Akshdeep Sharma, Prachi Jhanwar, Prachi Jhanwar, Deepak Bansal, Deepak Bansal, Amit Kumar, Amit Kumar, Maninder Kaur, Maninder Kaur, Shilpi Pandey, Shilpi Pandey, Prem Kumar, Prem Kumar, Dinesh Kumar, Dinesh Kumar, Kamaljit Rangra, Kamaljit Rangra, } "Comparative study of various release methods for gold surface micromachining," Journal of Micro/Nanolithography, MEMS, and MOEMS 13(1), 013005 (5 February 2014). https://doi.org/10.1117/1.JMM.13.1.013005 . Submission:


Wideband microwave switch by micromachining techniques
Proceedings of SPIE (September 07 1998)
Maskless lithography using off-the-shelf inkjet printer
Proceedings of SPIE (December 19 2006)
Anisotropic chemical etching of silicon
Proceedings of SPIE (April 15 1998)

Back to Top