1 April 1976 Generating an Error Analysis for an Airborne Radiometric System
Author Affiliations +
Abstract
This paper presents an error analysis for an airborne radiometric system. The system under scrutiny is a scanning radiometer operating at two wavelengths in either a warm or cold mode. Each wavelength channel consists of an array of N detectors. The long wavelength channel is used for display purposes (acquisition, tracking), whereas both channels are used for data reduction purposes. The data are recorded on analog and digital tapes (both sensor as well as general housekeeping data), reformatted and made ready to undergo stan-dard Fortran type operations. The sensor data consist primarily of target voltage waveforms interspersed among erroneous voltage pulses and white noise. It is desired to ascertain the peak values of the target voltage pulses and relate these peak values to target irradiances via the a priori laboratory calibration. Hence, it is observed that the errors can be classified as belonging to one of the following subsystems: 1) Calibration 2)The sensor itself 3) Data processing and reduction
A. J. Verderese, "Generating an Error Analysis for an Airborne Radiometric System," Optical Engineering 15(2), 152166 (1 April 1976). https://doi.org/10.1117/12.7971940 . Submission:
JOURNAL ARTICLE
7 PAGES


SHARE
RELATED CONTENT

Repeatability test of in-line gear measuring machine
Proceedings of SPIE (November 15 2011)
Oil-film dynamic coefficient testing system
Proceedings of SPIE (September 02 2003)
A novel calibration of the CAT system for joint internal...
Proceedings of SPIE (October 24 2006)
A Novel Timing Recovery for Read Channel Systems using a...
Proceedings of SPIE (September 09 2004)
Self-calibration of sensor networks
Proceedings of SPIE (August 07 2002)

Back to Top