1 October 1976 Design of a High Speed Optical Production Line
Author Affiliations +
Abstract
The engineering requirements for a high speed production line for optical elements have been investigated. The studies were based on a three-step process-diamond tubular tool generation, diamond pellet lapping and polishing with polyurethane bonded cerium oxide. Emphasis was placed on precision ground surface generation based on an analytical model. The generation process resulted in surfaces with a precision of one interference ring and an accuracy of three interference rings with respect to the desired radius of curvature. The lapping and polishing stages were designed to reduce the microstructure of the work while leaving the surface shape unaffected. At each stage of the process the surface figure was measured. A new testing technique was used to study and to quantify the microstructure of the lapped and polished surfaces. The microstructure was measured to 20 Angstroms peak-to-peak using a Scanning Fizeau Interferometer.
James J. Bohache, Gih-Horng Chen, Duncan T. Moore, "Design of a High Speed Optical Production Line," Optical Engineering 15(5), 155416 (1 October 1976). https://doi.org/10.1117/12.7972012 . Submission:
JOURNAL ARTICLE
8 PAGES


SHARE
RELATED CONTENT

Model-based polishing of meter size optics
Proceedings of SPIE (October 15 2013)
Results of a polishing study for SCHOTT XLD glasses
Proceedings of SPIE (September 24 2015)
Optimal polishing methods for high-energy optical fibers
Proceedings of SPIE (September 03 2010)
Supersmooth processing technology of optical elements
Proceedings of SPIE (October 06 2000)
Finish machining of optical components in mass production
Proceedings of SPIE (March 01 1991)
Optical Glass Finishing
Proceedings of SPIE (December 21 1989)

Back to Top