1 October 1976 Some Thoughts on Lens Mounting
Author Affiliations +
Abstract
The mounting of lenses is a major consideration in the manufacture of lenses. The design of the mount, the material used and the manufacturing methods can all significantly affect the performance, cost and profit margin in lens making. Various methods of mounting will be described and some ideas for improvement will be presented. The suggested improvements are based on the observation that the optical shop is a hostile environment for precision instruments and machines. The grinding materials and liquids are ruinous to precision tools. The one process in lens making that is unique to lens making is the degree of concentration on polishing spherical surfaces. To optimize the manufacturing process one should consider reducing precision requirements as much as possible in all the steps except for the polishing. This thinking leads to looking at new methods of assembly which can be done in clean room conditions. Modern epoxy cements, inch worms, interferometers, and minicomputer control units can be used in assembly to short cut the need for precision lens shaping and tight mounting tolerances.
Robert E. Hopkins, Robert E. Hopkins, } "Some Thoughts on Lens Mounting," Optical Engineering 15(5), 155428 (1 October 1976). https://doi.org/10.1117/12.7972014 . Submission:
JOURNAL ARTICLE
3 PAGES


SHARE
RELATED CONTENT

Additive manufacturing of tunable lenses
Proceedings of SPIE (February 15 2017)
Computer numeric control generation of toric surfaces
Proceedings of SPIE (May 25 1994)
Fabrication And Test Of X-Ray Optics
Proceedings of SPIE (November 26 1989)
Designing Lenses To Exploit Available Aspheric Technology
Proceedings of SPIE (September 15 1980)

Back to Top