1 October 1998 Thermal shock resistance of infrared transmitting windows and domes
Author Affiliations +
Optical Engineering, 37(10), (1998). doi:10.1117/1.601820
Abstract
Sudden exposure to a supersonic flight environment subjects a missile window, or missile dome, to intense convective heat loads stemming from the rise in temperature of the boundary layer. The thermal response of the window then results in temperature gradients through the thickness, which generate transient stresses that may exceed the tensile strength of the material, thus causing thermal-shockinduced fracture. Since most of the materials that possess favorable optical properties in the infrared (IR) are relatively weak brittle solids, the problem of selecting window or dome materials and assessing their performance on a fly-out trajectory requires a careful evaluation of the window’s ability to withstand thermally induced shocks. In this context, it is essential to keep in mind that the transient stress intensity depends on the nature of the heat flow as characterized by the Biot number (Bi). The allowable heat flux depends not only on intrinsic material properties but also on the heat transfer coefficient, if the condition Bi>1 holds, or the thickness of the window, if the condition Bi>1 applies. In a first approximation, the thermal shock performance of a ‘‘thick’’ window is controlled by the figure of merit (FoM)Bi>1=RH , i.e., the Hasselman parameter for strong shocks; in a thermally thin regime, however, if ?f designates the flexural strength the appropriate figure of merit is (FoM)Bi<1=nfr'h with n=1/2 for flat plates and n=2/3 for hemispherical shells, and not the Hasselman parameter R H 8 for mild shocks. Judging from the results of thermal shock testing performed elsewhere, we conclude that in a laminar flow environment the allowable heat flux on a thermally thin IR dome can be expressed as follows: Qlim=2R'H/L, where L is the dome thickness. This expression provides a direct means of obtaining the Machaltitude failure line for a dome of given thickness and given radius, if the initial wall temperature is known. Furthermore, it then becomes straightforward to assess the thermal shock resistance capability of a thicknessoptimized IR dome in terms of either the allowable heat load or, more simply, the allowable stagnation temperature.
Claude A. Klein, "Thermal shock resistance of infrared transmitting windows and domes," Optical Engineering 37(10), (1 October 1998). http://dx.doi.org/10.1117/1.601820
JOURNAL ARTICLE
11 PAGES


SHARE
KEYWORDS
Bismuth

Domes

Resistance

Missiles

Heat flux

Thermography

Failure analysis

Back to Top