1 May 1998 Image brightness variation of line-scan imaging systems using alternating-current-operated light source for object illumination
Author Affiliations +
Abstract
We develop a theoretical model of image brightness variation of line-scan imaging systems using an ac-operated light source for object illumination. First, we derive an equation that relates the lamp operating frequency F, the object transport speed v , the image resolution R0 , and the number nc of lamp operating cycles within the time interval of one scan line. It is shown that nc=FlvR0=Ftexp , where t exp=1/vR0 is the exposure time of an image sensor element and is the time interval within one scan line. Following this, we define a normalized modulation function M(nc ) that relates to the variation ?E of the light energy E= ? I (t) dt received by a sensor element over t exp , where I(t ) is the intensity of object illumination. Three types of periodic functions for I(t ) are considered for which closed-form solutions for M(nc ) can be obtained: squarewave, sinusoidal, and triangular-wave. For the square-wave function we show that M(nc ) is a periodic function of nc , with zeros occurring at integral values of nc and peaks occurring at odd multiples of 1/2, with the heights of these peaks decreasing as 1/2nc with increasing nc . For the sinusoidal and triangular-wave functions, M(nc ) has similar periodic behavior except that the heights of the peaks decrease as 1/?nc and 1/4nc respectively. These results indicate that the square-wave function can be used to represent the worst case for assessing the performance of an imaging system under different conditions. Accordingly, we show numerically that lamps operating at a low frequency F=50 Hz cannot be used for object illumination because the variation in image brightness is too large, and lamps operating at F=20 kHz are generally applicable except at high object transport speed, typically at 100 in./s. Finally, we point out that this theoretical model may also be applied to area-scan imaging systems, such as for video cameras. For these imaging systems, the normalized modulation function can be used to assess the variation of image brightness between one whole image and another, rather than between one scan line and another.
Tuan-Kay Lim, Tuan-Kay Lim, } "Image brightness variation of line-scan imaging systems using alternating-current-operated light source for object illumination," Optical Engineering 37(5), (1 May 1998). https://doi.org/10.1117/1.601683 . Submission:
JOURNAL ARTICLE
11 PAGES


SHARE
Back to Top