1 July 1999 Vertical cavity surface emitting laser based optoelectronic asynchronous transfer mode switch
Author Affiliations +
Abstract
Large broadband asynchronous transfer mode (ATM) switching nodes require novel hardware solutions that could benefit from the inclusion of optical interconnect technology, since electronic solutions are limited by pin out and by the capacitance/inductance of the interconnections. We propose, analyze and demonstrate a new three stage free space optical switch that utilizes vertical cavity surface emitting lasers (VCSELs) for the optical interconnections, a liquid crystal spatial light modulator (SLM) as a reconfigurable shutter and relatively simple optics for fan out and fan in. A custom complementary metal oxide semiconductor (CMOS) chip is required to introduce a time delay in the optical bit stream and to drive the VCSELs. Analysis shows that the switch should be scalable to 1024x 1024, which would require 2048 ~2 mW VCSELs.
Carl W. Wilmsen, Carl W. Wilmsen, Chunji Duan, Chunji Duan, James R. Collington, James R. Collington, Mark P. Dames, Mark P. Dames, William A. Crossland, William A. Crossland, } "Vertical cavity surface emitting laser based optoelectronic asynchronous transfer mode switch," Optical Engineering 38(7), (1 July 1999). https://doi.org/10.1117/1.602284 . Submission:
JOURNAL ARTICLE
7 PAGES


SHARE
RELATED CONTENT

Shutter-based switching core for an optical packet switch
Proceedings of SPIE (November 16 2004)
Packet switching network based on optical fan-in
Proceedings of SPIE (May 24 2000)
VCSEL-based free-space optoelectronic ATM router
Proceedings of SPIE (November 08 2001)
Free-space optical switching core for storage area network
Proceedings of SPIE (February 11 2005)
Joint operation of packet network and WDM network
Proceedings of SPIE (October 05 2000)
Optical routing with liquid crystal arrays
Proceedings of SPIE (November 08 2001)

Back to Top