1 August 2001 Simple method to calculate the radial energy and temperature distributions in diode-pumped solid-state laser rods
Author Affiliations +
Abstract
The major limiting factor in scaling solid state laser average power is thermal heating. A simple and effective solution, which is used to obtain pump and temperature distributions in the laser rod using an approximate formula to calculate the absorption of the pump ray in the rod, is provided. The calculated data fit well with the experimental data, which are obtained from an IR camera. This analysis can provide valuable data for efficient coupling of pump source and subsequent correction of the thermal distortion inside the laser resonator. Most important, one can clearly observe temperature distribution in the rod and temperature difference between the center and edge of the rod with an IR camera, which benefits adjustment of the pump diodes.
© (2001) Society of Photo-Optical Instrumentation Engineers (SPIE)
Wenjie Xie, Wenjie Xie, Siu Chung Tam, Siu Chung Tam, Yee Loy Lam, Yee Loy Lam, } "Simple method to calculate the radial energy and temperature distributions in diode-pumped solid-state laser rods," Optical Engineering 40(8), (1 August 2001). https://doi.org/10.1117/1.1386374 . Submission:
JOURNAL ARTICLE
5 PAGES


SHARE
RELATED CONTENT

Design of diode laser systems for solid state laser pumping
Proceedings of SPIE (November 13 2003)
Generation characteristics of diode-pumped Nd:YAG lasers
Proceedings of SPIE (February 28 1995)
Ultracompact diode-pumped solid state lasers
Proceedings of SPIE (April 16 1995)

Back to Top