1 August 2002 Nanometer deep shaping with fluid jet polishing
Author Affiliations +
Optical Engineering, 41(8), (2002). doi:10.1117/1.1489677
Abstract
We describe the theoretical dependence of various important parameters of the fluid jet polishing process on the material removal rate: the processing time, abrasive concentration, abrasive diameter, particle velocity, and the effect of scanning. Some recent experiments are described that prove that it is possible to remove very small amounts of material, less than 1 nm/min, using either short processing times or an appropriate slurry. The removal spot in the stationary case is compared to that in the translational case both theoretically and experimentally. From both a theoretical and an experimental point of view it is shown that the removal is in the ductile regime.
Silvia M. Booij, Hedser H. van Brug, Joseph J. M. Braat, Oliver W. Faehnle, "Nanometer deep shaping with fluid jet polishing," Optical Engineering 41(8), (1 August 2002). https://doi.org/10.1117/1.1489677
JOURNAL ARTICLE
6 PAGES


SHARE
RELATED CONTENT

Fabrication of large aperture SiC brazing mirror
Proceedings of SPIE (October 28 2016)
Computer-controlled fluid jet polishing
Proceedings of SPIE (November 14 2007)
Fluid jet polishing: removal process analysis
Proceedings of SPIE (September 06 1999)

Back to Top