1 December 2003 Gain-flattened ultra-wideband fiber amplifiers
Author Affiliations +
Abstract
This paper presents a novel design of a gain-flattened amplifier that covers an ultra-wide band including the S, C, and L bands. The amplifier has a split-band architecture, which amplifies the S-, C-, and L-band signals in separate paths and then recombines the amplified signals for the final output. Using a commercial software package VPI Component MakerTM, the design was simulated and tested for optimization. The gain and noise figure of the new amplifier were analyzed by computer simulation. A gain of ≈29 dB, a ripple factor of about 1.7 dB, a nominal low noise figure <5 dB, and gain-bandwidth products >120 nm can be achieved.
© (2003) Society of Photo-Optical Instrumentation Engineers (SPIE)
Yang Cao, Yang Cao, M. Yasin Akhtar Raja, M. Yasin Akhtar Raja, } "Gain-flattened ultra-wideband fiber amplifiers," Optical Engineering 42(12), (1 December 2003). https://doi.org/10.1117/1.1623499 . Submission:
JOURNAL ARTICLE
5 PAGES


SHARE
RELATED CONTENT


Back to Top