1 October 2004 Remote sensing using passive infrared Stokes parameters
Author Affiliations +
Optical Engineering, 43(10), (2004). doi:10.1117/1.1782614
Abstract
We address the problem of detecting vehicle targets on the ground by means of an autonomous polarimetric sensor on board a high-altitude air- or spaceborne platform. We studied a sensor system that incorporates a micropolarizer array, a microscanner, and digital signal processors that host algorithms for detecting small targets. These algorithms use statistical techniques to fuse a target's Stokes-vector infrared signature measurements. Fusion is achieved by constructing the joint statistical measures for the target's polarization states. Those states are expressed in terms of the intensity, the percentage of linear polarization, and the angle of the polarization plane. The performance of the sensor system on synthetic polarimetric infrared imagery was evaluated. Relatively good detection and low false-alarm probabilities were achieved even when the number of pixels on targets is as small as four. This is the first report of the development and evaluation of automatic detection in polarimetric imagery containing targets subtending only a small number of pixels.
Firooz A. Sadjadi, Cornell S. L. Chun, "Remote sensing using passive infrared Stokes parameters," Optical Engineering 43(10), (1 October 2004). http://dx.doi.org/10.1117/1.1782614
JOURNAL ARTICLE
9 PAGES


SHARE
KEYWORDS
Target detection

Polarimetry

Polarization

Sensors

Infrared radiation

Infrared imaging

Infrared sensors

Back to Top