1 January 2006 Methane detection from space: use of sunglint
Author Affiliations +
Optical Engineering, 45(1), 016201 (2006). doi:10.1117/1.2150835
Abstract
Methane seepage is indicative of petroleum or natural gas reserves. Techniques aimed at detecting methane seepage with surface-based instrumentation have progressed significantly in recent years. These techniques rely on measurement of light attenuation due to methane absorption of short wave infrared (SWIR) radiation. Detection of methane seepage over water bodies with electro-optical remote sensing has been limited by the low surface reflectance of water. Also, due to sensor saturation, imagery over sunglint is commonly discarded in satellite remote sensing, because the glint conditions produce high surface reflectance. However, recent measurements in the SWIR of sunglint regions have revealed that the surface reflectance is spectrally flat and enhanced without causing saturation. This higher surface reflectance in sunglint regions allow for retrieval of the total column methane amount using ratios of measured radiances at wavelengths inside and outside the methane SWIR-absorbing channels. The methane retrieval method presented here, based on shortwave infrared band ratios in sunglint regions, allows for detection of methane seepage over the Earth's oceans and lakes, and the detection of possible petroleum or natural gas reserves. Radiative transfer simulations are used to demonstrate the capabilities offered by this technique.
North F. Larsen, Knut H. Stamnes, "Methane detection from space: use of sunglint," Optical Engineering 45(1), 016201 (1 January 2006). https://doi.org/10.1117/1.2150835
JOURNAL ARTICLE
8 PAGES


SHARE
Back to Top