Nitrogen is one of the essential nutrients required for crop growth, and hence should be applied efficiently for attaining optimum yield. To fulfil nitrogen need, absorbed nitrogen in the plant is required to be estimated. Various methods are available to estimate crop nitrogen such as tissue analysis using the methods of Kjeldahl and Dumas, which are accurate, but time-consuming and destructive. Satellite imagery provides a more extensive field view. However, they are limited to their spatial and temporal resolution. Unmanned aerial vehicle (UAV) is emerging as a promising tool that can provide the status of crop nitrogen rapidly with high spatial and temporal resolution. The objective of the study was to evaluate UAV-based imageries to show nitrogen status and predict rice yield at different growth stages. The experiments were conducted using two rice cultivars, six nitrogen applications, two water management practices, and with three replications. Soil plant analysis development (SPAD) meter readings were collected at various growth stages. First, aerial imageries of experimental site were collected using an octocopter UAV equipped with a multispectral sensor that provides reflectance values in four different bands (red, green, red edge, and near-infrared) along with SPAD values for respective flight. Second, aerial images were processed in pix4D software, to identify the most appropriate vegetation index that shows nitrogen status variation in the field and to predict yield using different vegetation indices. Nine vegetation indices were considered: ratio vegetation index, normalized difference vegetation index, normalized green red difference index, red edge difference vegetation index, green ratio vegetation index, green normalized difference vegetation index (GNDVI), wide dynamic range vegetation index, transformed normalized difference vegetation index (TNDVI), and normalized difference red edge. After that, a linear regression model was developed between the representative index and SPAD values. Finally, linear regression models developed by using VI and SPAD values were evaluated and results revealed that GNDVI-based model simulates SPAD values with R² of 0.49, 0.49, and 0.74 at panicle, milky, and booting stages, respectively. It is also found that TNDVI-based linear regression model predicts yield with R² of 0.71 at milky stage.