1 April 2006 Application of polysilazane to etch mask in pattern transfer processes for deep and vacuum ultraviolet lithography
Yasuhiko Sato, Junko Abe
Author Affiliations +
Abstract
A polysilazane is investigated for a spin-on glass (SOG) used for a middle layer in a trilevel resist system. Higher film density is required for the middle layer to obtain higher etch resistance during the underlayer etching. The compositions of the polysilazane baked at 200°C and 300°C are Si0.42O0.34C0.40N0.20 and Si0.29O0.65C0.10N0.05, respectively, which are determined by x-ray photoelectron spectroscopy. The polysilazane is converted to silicon-oxide-like compositions by baking at 300°C. The film density and etch rate of SOG made from polysilazane are compared with that of polysiloxsane on condition that both films are baked at 300°C. The film density of the SOG made from the polysilazane is 2.07 g/cm3, which is higher than 1.87 g/cm3 of the conventional SOG made from a polysiloxsan. The etch resistance of the SOG made from the polysilazane is improved by 90% compared with that of the SOG made from the polysiloxsane due to the increased film density.
©(2006) Society of Photo-Optical Instrumentation Engineers (SPIE)
Yasuhiko Sato and Junko Abe "Application of polysilazane to etch mask in pattern transfer processes for deep and vacuum ultraviolet lithography," Journal of Micro/Nanolithography, MEMS, and MOEMS 5(2), 023007 (1 April 2006). https://doi.org/10.1117/1.2198841
Published: 1 April 2006
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Etching

Silicon

Resistance

Reflectivity

Chemical vapor deposition

Lithography

Photomasks

Back to Top