You have requested a machine translation of selected content from our databases. This functionality is provided solely for your convenience and is in no way intended to replace human translation. Neither SPIE nor the owners and publishers of the content make, and they explicitly disclaim, any express or implied representations or warranties of any kind, including, without limitation, representations and warranties as to the functionality of the translation feature or the accuracy or completeness of the translations.
Translations are not retained in our system. Your use of this feature and the translations is subject to all use restrictions contained in the Terms and Conditions of Use of the SPIE website.
1 April 2006Micromachining of 316LVM stainless steel tubes using periodic acousto-optic modulation of pulsed Nd:YAG lasers for cardiovascular stent applications
Optoelectronic techniques can be used in laser applications in biomedical instrumentation to achieve better flexibility and control of the available optical power. These techniques enable the processing and manufacturing of biomedical implants like cardiovascular stents and micrometallic components with reduced heat-affected zone (HAZ) and extremely precise edge cutting. The present investigations deal with the study of laser piercing routines and further profile cutting of thin stainless steel sheet tubes for biomedical implant manufacturing. The process is performed using an acousto-optic (AO) modulator-based pulsed Nd:YAG laser. The AO modulator used in the experiments is a Bragg diffraction device. During the piercing of holes, the focused laser power is gradually increased from a low value and finally reaches the maximum as the beam goes deeper into the material. The most suitable value of dwell time is found to be 50 ms. A nine step staircase modulating voltage with a maximum ac component of 800 mV is used, and the laser power is 4 W in TEM00 operation. The acousto-optic modulator-based pulsed Nd:YAG laser is capable of cutting extremely complex geometries of stents on 316LVM tubing. Laser cutting results in a kerf width of 20.5±0.5 µm. Precise strut dimensions of 115±15 µm for subsidiary strut, 150±15 µm for main strut, and 150±15 µm for the link are also obtained. With the piercing routine, extremely fine holes with reduced heat-affected zones are produced, and this quality is reflected during consequent machining of required profiles for implants.
The alert did not successfully save. Please try again later.
S. K. Sudheer, V. P. Mahadevan Pillai, V. Unnikrishnan Nayar, Yavar Pothiawala, Devesh Kothwala, Dhiraj Lal Kotadia, "Micromachining of 316LVM stainless steel tubes using periodic acousto-optic modulation of pulsed Nd:YAG lasers for cardiovascular stent applications," J. Micro/Nanolith. MEMS MOEMS 5(2) 023010 (1 April 2006) https://doi.org/10.1117/1.2201038