1 October 2007 Limiting factors for electron beam lithography when using ultra-thin hydrogen silsesquioxane layers
Anda Elena Grigorescu, Marco C. van der Krogt, Cees W. Hagen
Author Affiliations +
Abstract
Isolated dots and lines with 6 nm width are written in 20-nm-thick hydrogen silsesquioxane (HSQ) layers on silicon substrates, using 100-keV electron beam lithography. The main factors that might limit the resolution, i.e., beam size, writing strategy, resist material, electron dose, and development process, are discussed. We demonstrate that, by adjusting the development process, a very high resolution can be obtained. We report the achievement of 7 nm lines at a 20-nm pitch written in a 10-nm-thick HSQ layer, using a potassium-hydroxide (KOH)-based developer instead of a classical tetra-methyl-ammonium hydroxide (TMAH) developer. This is the smallest pitch achieved to date using HSQ resist. We think that the resolution can be improved further, and is presently limited by either the beam diameter (which was not measured separately) or by the not-fully-optimized development process.
©(2007) Society of Photo-Optical Instrumentation Engineers (SPIE)
Anda Elena Grigorescu, Marco C. van der Krogt, and Cees W. Hagen "Limiting factors for electron beam lithography when using ultra-thin hydrogen silsesquioxane layers," Journal of Micro/Nanolithography, MEMS, and MOEMS 6(4), 043006 (1 October 2007). https://doi.org/10.1117/1.2816459
Published: 1 October 2007
Lens.org Logo
CITATIONS
Cited by 10 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Electron beam lithography

Electron beams

Scanning electron microscopy

Hydrogen

Silicon

Photoresist processing

Photomicroscopy

Back to Top