Underwater survey, compared to land archaeology, needs some specific techniques, because the application of some active 3D sensor, such as laser scanner, is obviously impossible. The necessity to produce three-dimensional survey, offering the same accuracy of classical terrestrial laserscanning or photogrammetric methods, combined with the request of low costs and rapid solutions, led the researchers to test and apply oftentimes image-based techniques.<p> </p> In the last two years the Ca' Foscari University and University IUAV of Venice are conducting a research on the application of integrated techniques to support underwater metric documentation, comparing them to the manual traditional one. The gained experience (and confirmed by other recently published papers) shows that the actual multiimage digital photogrammetry is a good solution for the underwater archaeology. This approach is useful both from a metric and from a recording point of view, because it achieves high quality results, such as accurate 3D models or 2D representations, offering a complete documentation of underwater sites.<p> </p> But photogrammetry has to be supported by a topographical survey (to acquire ground control points - GCP) to georeference all the finds in the same reference system. This paper presents the integrated survey of two roman shipwrecks, approaching differently in the GCP’s acquisition just for the different morphological characteristic of the sites. The wrecks’ cargos are huge marble blocks, presenting differences in quantities, layout and depths. Those characteristics determine the choice of the topographic survey. <p> </p>The results of the survey are two 3D polygonal textured models of the sites, which can be easily used for different analyses and reconstructive hypothesis, opening new possibilities of documentation with both specialists and the wider public. Furthermore, 3D models are the geometric base for 2D orthophoto and cross section extraction. <p> </p>The paper will illustrate all the phases regarding the survey’s design, acquisition and realization and the data processing to obtain 2D and 3D final representation.
This research is focused on the analysis of the potential of a close range aerial photogrammetry system, which is accessible both in economic terms and in terms of simplicity of use. In particular the Go Pro Hero3 Black Edition and the Parrot Ar. Drone 2.0 were studied. There are essentially two limitations to the system and they were found for both the instruments used. Indeed, the frames captured by the Go Pro are subject to great distortion and consequently pose numerous calibration problems. On the other hand, the limitation of the system lies in the difficulty of maintaining a flight configuration suitable for photogrammetric purposes in unfavourable environmental conditions. The aim of this research is to analyse how far the limitations highlighted can influence the precision of the survey and consequent quality of the results obtained. To this end, the integrated GoPro and Parrot system was used during a survey campaign on the Altilia archaeological site, in Molise. The data obtained was compared with that gathered by more traditional methods, such as the laser scanner. The system was employed in the field of archaeology because here the question of cost often has a considerable importance and the metric aspect is frequently subordinate to the qualitative and interpretative aspects. Herein one of the products of these systems; the orthophoto will be analysed, which is particularly useful in archaeology, especially in situations such as this dig in which there aren’t many structures in elevation present. The system proposed has proven to be an accessible solution for producing an aerial documentation, which adds the excellent quality of the result to metric data for which the precision is known.