The forward and backward cascaded stimulated Brillouin scattering(SBS) in the backward pumped S band distributed G652 fiber Raman amplifier have been researched, pumped by the tunable power at 1428nm fiber Raman laser and signal source is a tunable power external cavity laser (ECL) with narrow spectral bandwidth (<100MHz). The threshold power of backward Stokes the first and second stimulated Brillouin scattering SB1- and SB2- in the backward pumped S band distributed fiber Raman amplifier is 5mW and 67.6mW, respectively. The Stokes stimulated Brillouin scattering lines is amplified by fiber Raman amplifier and fiber Brillouin amplifier. The total GA is production of the gain of Raman GR and the gain of Brillouin amplifier GB. GA=GR×GB. In experimental work, the saturation gain of SB1- and SB2- is about 50dB and 65dB respectively and the saturation gain of 25km G652 backward FRA is about 25dB, so the gain of backward fiber Brillouin amplifier SB1- and SB2- are about 25dB and 40dB, respectively. The forward SBS does not obey the common theory that only weakening backward-SBS lines existed, according to conservation of energy and momentum and wave vector selected rule. Because the wave-guide characters weaken the wave vector rule, but the forward transmit sound wave-guide forward Brillouin scattering lines are generated and amplified in S band G652 FRA. The stimulated threshold power of the forward first Stokes SBS (SB1- ) in the backward pumped FRA is 6.6mW. In experimental work, the saturation gain of SB1- is about 49dB and the saturation gain of 25km G652 backward FRA is about 10dB, so the gain of SB1- in the forward fiber Brillouin amplifier is about 39dB.
Now the communication band of fiber focuses on C-band, but with increasing demand of fiber communication capacity, the communication band will extend to the S-band and L-band and fiber Raman amplifier will play a very important role in this process. In this paper, actual fiber Raman gain spectrum using single high power fiber Raman laser as pump was tested and the proper chirped Bragg fiber grating as gain flattening filter was designed to flatten actually tested gain spectrum. Besides, FWDM (film wavelength division multiplexer) is used as the multiplexer of signals and 1427nm/1505nm CWDM (coarse wavelength division multiplexer) is used as pump-signal coupler. The gain media are 50 km G652 fiber and 5km DCF (dispersion compensation fiber). The gain is 10dB of S-band fiber dispersion compensation Raman amplifier from1487.88nm~1541.88nm (total 53nm bandwidth) with gain ripple ± 0.6dB was successfully obtained. Besides, the effect caused by different location ways of different type fibers was also discussed. It is very significant for extending range of communication band of fiber and increasing the capacity of fiber communication especially for ultra-long haul and ultra-high capacity communication system.
The amplification effect on forward and backward stimulated Brillouin scattering lines in the forward pumped S band discrete DCF fiber Raman amplifier (FRA) has been studied. The pumped threshold power of the forward first order Stokes SBS (FSB1- ), second order Stokes SBS (FSB2-) and third order SBS (FSB3-) in the forward pumped FRA are 1.5 mW, 1.4 mW and 1.7 mW respectively. The Stokes SBS lines are amplified by FRA and fiber Brillouin amplifier (FBA) at the same time. The gain of amplification is given as GA=GR multiplied by GB where GR is Raman gain and GB is Brillouin gain. In the experiments, the saturation gain of FSB1-, FSB2- and FSB3- are about 52dB, 65dB and 65dB respectively. The saturation Raman gain of 10km DCF forward FRA is about 14dB, so the Brillouin gain of FSB1- , FSB2- and FSB3- are about 38dB, 51dB and 51dBrespectively. There are pumped threshold power of the first order, second order and third order Stokes backward SBS (B-SBS) line BSB1-, BSB2- and BSB3- in the forward pumped discrete DCF FRA, and they are about 4.7mW, 17.1mW and 67mW respectively. The saturation gain of the first order, second and third Stokes backward SBS line BSB1-, BSB2-and BSB3- are about 60dB and the saturation gain of 10km DCF forward pumped FRA is about 27dB, so the gain of FBA is about 33dB. The forward and backward cascaded SBS lines have been observed.
C-band and S-band fiber Raman gain spectrum pumped by single wavelength high power fiber Raman laser were tested and the proper chirped Bragg fiber grating as gain flattening filter was designed to flatten actually tested gain spectrum. Besides, FWDM (filter wavelength division multiplexer) and 1427nm/1505nm CWDM (coarse wavelength division multiplexer) are used as C-band and S-band fiber Raman amplifier pump-signal couplers respectively. The gain media are 50 km G652 fiber and 5km DCF (dispersion compensation fiber). C-band fiber dispersion compensation Raman amplifier with bandwidth from 1519nm to 1574nm (55nm) and average gain 15.2dB and ripple ±0.8dB was successfully obtained. S-band fiber dispersion compensation Raman amplifier with bandwidth from 1488nm to 1541nm (53nm) and average gain 10.1dB and ripple ±0.9dB was successfully obtained. During the test of C-band fiber Raman amplifiers, broadband ASE light source and WDM-emulator were used to simulate the DWDM (dense wavelength division multiplexing) signal source that can make the whole test more accurate. It is very significant for extending range of communication band of fiber and increasing the capacity of fiber communication especially for ultra-long haul and ultra-high capacity communication system. At last, the result of experiment using these setup and influence caused by gain flattening filter and different type fibers location arrangements (G652 fiber and DCF) and corresponding solutions were also discussed.
The forward and backward cascaded stimulated Brillouin scattering (SBS) in the backward pumped S band distributed G652 fiber Raman amplifier have been researched, pumped by the tunable power 1428nm fiber Raman laser and signal source is a tunable narrow spectral bandwidth (<100MHz)ECL. The forward SBS does not obey the common theory, that only weaken backward-SBS lines existed, according to conservation of energy and momentum and wave vector selected rule. Because the wave-guide character weaken the wave vector rule, the forward transmit sound wave-guide forward Brillouin scattering lines are generated and amplified in S band G652 FRA. Forward SBS that is amplified phenomena of transmit sound wave Brillouin scattering in the G652 FRA, during pump power is larger than the threshold value of SBS in a S band G652 FRA. Two-order SBS in the Stokes region is observed during the pump power is increased. When the FRA pump power is further increased, Cascaded SBS lines and comb profile are observed.
The cascaded forward stimulated Brillouin scattering (SBS) in the S band distributed G652 fiber Raman amplifier forward pumped and backward pumped by the tunable power fiber laser and signal source is a tunable narrow spectral bandwidth(<100MHz)ECL have been studied. Forward SBS does not obey the common theory, that only weaken backward-SBS lines existed, according to conservation of energy and momentum and wave vector selected rule. Because the wave-guide character weaken the wave vector rule. The forward transmit sound wave-guide Brillouin scattering lines are generated and amplified in FRA. Forward SBS that is amplified phenomena of transmit sound wave Brillouin scattering in the FRA, during pump power is larger than the threshold value of SBS in a S band G652 FRA. The 2 orders Stokes forward Brillouin lines are present during forward pump power of FRA is 920mW, the pump power of BP line is 7.7dBm and the FRA gain is 15.05dB, the power of first order Brillouin lines is smaller than the second Brillouin scattering line. When pump power is further increased, cascaded SBS lines and comb profile are observed. The even order SBS lines is stronger than odd order SBS lines, The odd order SBS lines are named Brillouin- Rayleigh scattering lines.
5kmDCF-50kmG652 fiber dispersion compensation FRA pumped by three-wavelength Raman fiber laser has been researched. Dispersion and dispersion slope can be compensated in the dispersion compensation FRA simultaneously. Cascaded pump fiber laser is an all fiber technology, and high output power above 3W can be achieved. The Raman fiber lasers which operating at wavelengths of 1428,1455 and 1466nm have been used to simultaneously pump dispersion compensation fiber Raman amplifier. Simulated annealing algorithm is adopted to give automatic pump power configuration in multiwave backward-pumped dispersion compensation FRA. Simulated annealing algorithm imitates physical annealing process in order to seek the most optimal key. We studied the dispersion compensation FRA with the pump power configuration of optimal design in experiment, and the spectrums of gain and noise figure (NF) have been measured. When pump power is 1250mw and signal power is 0dBm,we get 55nm flat-gain bandwidth, and noise figure is less than -0.93dB, while the gain flatness is less than 3dB and gain is more than 21.32dB;when pump power is 1500mw,we get 45nm flat-gain bandwidth, and noise figure is less than -1.79dB,while the gain flatness is less than 3dB and gain is more than 27.77dB.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.