Organic thin films based on composite materials of semiconducting dibenzo-tetrathiafulvalene (DB-TTF) and insulating styrenic matrices (Polystyrene (PS10k) and Poly-alpha methylstyrene (PAMS10k) ) have been fabricated by the wire-bar coating technique in ambient conditions (air, light, humidity) and contrasted with the ones prepared by thermally evaporating the organic semiconductor. The transistors fabricated with DB-TTF:PS10k composites show a clear fieldeffect behavior with p-type characteristics, exhibiting charge carriers mobilities in the range of 0.01 cm<sup>2</sup>/Vs, fully comparable with the films obtained by thermal evaporation. However, while the thermally evaporated films show poor stability in air, the wire-bar coated composites films and devices are highly reproducible and exhibit lower threshold voltage values. Thus, we demonstrate the suitability of the wire-bar technique for manufacturing large area devices.
Single-molecule magnets (SMM) have a large-spin ground state with appreciable magnetic anisotropy, resulting in a barrier for the spin reversal As a consequence, interesting magnetic properties such as out-of-phase ac magnetic susceptibility signals and stepwise magnetization hysteresis loops are observed. In addition to resonant magnetization tunnelling, during the last few years several other interesting phenomena have also been reported. The origin of the slow magnetization relaxation rates as well as of other phenomena are due to individual molecules rather than to long-range ordering; as confirmed by magnetization relaxation and heat capacity studies. Therefore, SMM represent nanoscale magnetic particles of a sharply defined size that offer the potential access to the ultimate high-density information storage devices as well as for quantum computing applications. However, if a truly molecular computational device based on SMM is to be achieved, new systematic studies that allow us to find a proper way to address properly oriented individual molecules or molecular aggregates onto the surface of a thin film, where each molecule or molecular aggregate can be used as a bit of information, are highly required. Here we report a new soft, reliable and simple methodology to address individual Mn<sub>12</sub> molecules onto a film surface, as revealed by Atomic Force Microscopy (AFM) and Magnetic Force Microscopy (MFM) images. Moreover, the advantageous properties of polymeric matrices, such as flexibility, transparency and low density, make this type of materials very interesting for potential applications.