A continuous-wave (CW) NIR carbon-dioxide monitoring system, incorporating Wavelength Modulation Spectroscopy (WMS), has been developed and was tested aboard the Spirit of Goodyear airship platform. The data shows sensitivities nearly identical to previous ground-based tests but with much higher information rates (100Hz). These tests were conducted over regions with varying ground albedo and included path lengths up to 1.5 km. The system utilized commercial-off-the-shelf (COTS) components including telecom laser diodes and amplifiers. Currently, the system is limited by Erbium Doped Fiber Amplifier (EDFA) spectral bandwdith, but the ever-increasing average power of quantum cascade lasers coupled with the development of midwave fiber technology could make this CW-based architecture a viable solution for future airborne sensors in the MWIR region.
We report standoff open path atmospheric CO2 monitoring with a field deployable, turn key system including a continuous wave (CW)distributed feedback (DFB) laser and an erbium doped fiber amplifier (EDFA) at 1.5-μm. A sensitivity of 28-ppm was achieved over 1.5-km of open air with 200-pW of received power, a 10s acquisition time, and a peak absorption cross section of 8x10<sup>-23</sup>. This sensitivity corresponds to an error in fractional absorbance of 8x10<sup>-3</sup>. Closed cell lab sensitivities are better than 3000ppm*m, an error in fractional absorbance of 5x10<sup>-4</sup>. These results have been achieved using space qualified laser components, un-cooled InGaAs detectors, off the shelf electronics in a rugged all fiber architecture.
An innovative system architecture for a real time Active Imaging Polarimeter has been developed. The system benefits from very few hardware components (all of which are off the shelf) and a high performance signal recovery algorithm. An electo-optic modulator imposes a waveform of a defined frequency onto the optical signal from a standard telecom laser diode and is transmitted with a known polarization. A unique polarization signature is reflected off a target and imaged through different polarization analyzers onto four quadrants of a high frame rate, near infrared, focal plane array. Using knowledge of the modulation frequency, lock-in amplifier algorithms enable measurement of the received beam intensity and therefore polarization with high SNR performance. Multiple signals (each at unique modulation frequencies) can be differentiated and manipulated (in waveform, wavelength and polarization) to serve many imaging applications. The active imager architecture operates in turbid atmospheres day or night. This technique and its variations provide the necessary tools for a new approach to active imaging, polarimetry, 3D ranging and trace gas imaging.
Significant progress has been made in the performance, qualification and validation of Active Remote Sensing systems to address complex questions in climate science from satellites in low earth orbit. During the past year, ITT has completed the design, qualified the components, and validated the performance of sophisticated Tunable Diode Laser Absorption Spectroscopy systems for airborne and space missions. ITT has shown that measurement of total column CO<sub>2</sub> to an accuracy of 0.5% can be readily achieved using a 5 watt laser, 1 meter telescope and digital signal processing techniques to reject sunlight and noise. Furthermore, the design exploits the proven high reliability of photonic components developed by the telecom industry. ITT testing validated that these components survive launch and multi-year operation in space without significant degradation. Using a scaled sensor, the ground based validation campaign demonstrated the ability to accurately retrieve the CO<sub>2</sub> diurnal cycle as well the automotive induced variations in CO<sub>2</sub> observed in urban settings. These data validate the end-end sensor performance model and retrieval algorithms, which have previously been used to design a space based CO<sub>2</sub> sensor proposed to NASA. ITT will discuss the application of these technologies to other atmospheric constituents. Combined, these results serve to demonstrate that laser based remote sensing of key components of the atmosphere which address global climate change can be achieved from low earth orbit without further development.