With the concern of environmental protection and reducing the fossil fuel consumption, combustion processes need to be more efficient and less contaminable. Therefore, the ability to obtain important thermophysical parameters is crucial to combustion research and combustor design. Traditional surveying techniques were difficult to apply in a confined space, especially the physically intrusions of detectors can alter the combustion processes. Laser-based diagnostic techniques, like CARS, SVRS, PLIF and TDLAS, allow the in situ, non-intrusive, spatially and temporally resolved measurements of combustion parameters in hostile environments. We report here a new non-intrusive optical diagnostic technique, based on laser-induced thermal grating. Thermal gratings generated in NO2/N2 binary mixtures, arise from the nonlinear interaction between the medium and the light radiation from the interference of two pulsed, frequency-doubled Nd:YAG lasers (532 nm). This leads to the formation of a dynamic grating through the resonant absorption and the subsequent collisional relaxation. By the temporally resolved detection of a continuous wave, frequency-doubled Nd:YVO4 probe laser beam (671 nm) diffracted by LITG. The temporal behavior of the signal is a function of the local temperature and other properties of gas, various parameters of the target gas can be extracted by analyzing the signal. The accurate singleshot temperature measurements were carried out at different test conditions using a stainless steel pressurized cell, data averaged on 100 laser shots were compared with simultaneously recorded thermocouple data, and the results were consistent with each other. The LITG signal is shown to grow with increasing the gas pressure and is spatially coherent, which makes the LITG thermometry technique a promising candidate in high pressure environments.
In the working process of chemical oxy-iodigenne laser(COIL), the change of iodine pool pressure is complicated. As a result, it causes some mis-judgements, such as the damage of heater and the leakage of iodine steam. Further more, when the heater electric circuit is in a single working status, and after the heater switch is on or off, there exists a buffer time for the stabilization of iodine pool pressure, which is a relatively long time, and the minimum buffer pressure exceeds to 19 torr . Of course, it increases the preparing time for steady operation of laser, and reduces the quality of laser beam. In this paper, we study the iodine pool pressure of COIL in non-equilibrium condition, and analyze the mutation and the serious buffer phenomenon of iodine steam pressure. At the same time, we design an automatic control system for iodine pool pressure, which consists of five modules, such as data collection, automatic control, manual control, heater electric circuit, and the setting and display of pressure. This system uses two kinds of heater electric circuits, in this way, the serious buffer phenomenon of iodine pool pressure is effectively avoided. As a result, the maximal buffer pressure reduces to 4 torr, this makes sure that the iodine steam pressure is suitable for the operation of COIL, which produces a good condition for the steady operation of laser system and an excellent laser output.