KEYWORDS: Modulation, Radio over Fiber, Single mode fibers, Hybrid fiber radio, Signal detection, Nonlinear optics, Radio optics, Signal generators, Optical engineering, Forward error correction
A simple bidirectional radio over fiber (RoF) design based on orthogonal frequency division multiplexing (OFDM)-based millimeter wave (mm-wave) signal generation and transmission with compensation of linear and non-linear impairment with the aid of sparse second-order Volterra non-linear equalizer (S2-VNLE) is proposed. At the central station (CS), an optical 60 GHz OFDM-based mm-wave downlink signal is generated by a 16-QAM downlink radio frequency (RF) signal. The generated OFDM-based downlink mm-wave signal is transmitted to the base station (BS) via bidirectional single-mode fiber (SMF) of length 75 km. At BS, the downlink signal is photo detected and transmitted via an antenna to the user end. The 16-QAM uplink RF signal, obtained via a receiving antenna from the user end, is modulated on the unused carrier of the downlink mm-wave signal. The modulated uplink signal is transmitted to the CS through the same bidirectional fiber. The carrier reuse and fiber reuse reduce the system complexity. However, the simultaneous signal co-propagation may induce linear and non-linear impairment, further degrading the system performance and has to be compensated. The compensation of linear and non-linear impairment is done by full Volterra non-linear equalization (FVNLE). However, pruning the insignificant Volterra filter coefficient enables a reduction in computational complexity. The sparse second-order Volterra non-linear equalization (S2-VNLE) is obtained by l1-regularization to cut off the kernels with a moderate contribution. The weights of the tap coefficient are updated by the RLS algorithm. The transmission performance of compensated bidirectional RoF system is investigated. The performance analysis of the bidirectional RoF system shows improved efficiency, having performance closer to FVNLE with reduced system and computational complexity.
KEYWORDS: Orthogonal frequency division multiplexing, Receivers, Telecommunications, Signal to noise ratio, Modulation, Networks, Systems modeling, Transmitters, Interference (communication), Electronics
The technique of Orthogonal frequency multiplexing (OFDM) is used to mitigate the multipath effects and to achieve better data rate. When these systems are extended to enable multiple access wireless multimedia communications they are more beneficial. The performance of the OFDM systems degrades with frequency offset and phase offset. The OFDM multiple access (OFDMA) technology allots groups of the OFDM subcarriers allocated to different users for transmission. In this paper we study the interference effects of the individual subcarriers with the neighbouring subcarriers which also plays a role in the system degradation is termed as Multiuser Interference (MUI). The effect of Carrier frequency offset (CFO) on these systems is also taken in account. There are conventional CFO compensation methods for OFDMA systems the CFOs are usually compensated by directly eliminating the intercarrier interference (ICI) caused by the residual CFOs for individual users.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.