CEA and Sofradir have been involved for 7 years in studies related to a large format detector development for science and astronomy applications. These studies are linked with ESA's Near Infrared Large Format Sensor Array roadmap which aims to develop a 2Kx2K large format low flux low noise device. The ALFA (Astronomical Large Focal plane Array) detector is currently at design, manufacturing and validation phase at CEA and Sofradir. This paper will present the very last achievements of the ALFA development with a specific focus on the readout integrated circuit design itself. Features and specification of the 2048x2048 15μm pitch with Source Follower Detector (SFD) input stage will be described. Apart from ESA development, European Commission is also contributing to the large detector development thanks to ASTEROID (AStronomical TEchnology EuROpean Infrared detector Development) program founded by REA (Research European Agency). ASTEROID main objectives are to develop very large raw materials (CdZnTe substrate, HgCdTe epilayer…) compatible with the manufacturing of very large detectors in volume keeping the same level of performance. Organization and status of this program will be presented where high synergy with 2K² ALFA detector are included.
Infrared focal plane arrays (IRFPA) are widely used to perform high quality measurements such as spectrum acquisition at high rate, ballistic missile defense, gas detection, and hyperspectral imaging. For these applications, the fixed pattern noise represents one of the major limiting factors of the array performance. This sensor imperfection refers to the nonuniformity between pixels, and is partially caused by disparities of the cut-off wavenumbers. In this work, we focus particularly on mercury cadmium telluride (HgCdTe), which is the most important material of IR cooled detector applications. Among the many advantages of this ternary alloy is the tunability of the bandgap energy with Cadmium composition, as well as the high quantum efficiency. In order to predict and understand spectral inhomogeneities of HgCdTe-based IRFPA, we propose a modeling approach based on the description of optical phenomena inside the pixels. The model considers the p-n junctions as a unique absorbent bulk layer, and derives the sensitivity of the global structure to both Cadmium composition and HgCdTe layer thickness. For this purpose, HgCdTe optical and material properties were necessary to be known at low temperature (80K), in our operating conditions. We therefore achieved the calculation of the real part of the refractive index using subtracti
Infrared Focal Plane Arrays (FPA) are increasingly used to measure multi- or hyperspectral images. Therefore, it is crucial to control and modelize their spectral response. The purpose of this paper is to propose a modeling approach, adjustable by experimental data, and applicable to the main cooled detector technologies. A physical model is presented, taking into account various optogeometrical properties of the detector, such as disparities of the pixels cut-off wavelengths. It describes the optical absorption phenomenon inside the pixel, by considering it as a stack of optical bulk layers. Then, an analytical model is proposed, based on the interference phenomenon occurring into the structure. This model considers only the three major waves interfering. It represents a good approximation of the physical model and a complementary understanding of the optical process inside the structure. This approach is applied to classical cooled FPAs as well as to specific instruments such as Microspoc (MICRO SPectrometer On Chip), a concept of miniaturized infrared Fourier transform spectrometer, integrated on a classical Mercury-Cadmium-Telluride FPA, and cooled by a cryostat.