Due to 2 μm band in the absorption of water and CO<sub>2</sub>, the diode pumped solid state lasers with wavelength around 2 μm have important applications in laser medicine and remote sensing, such as it can be used as a scalpe or a light source of Coherent Doppler Wind Lidar and Differential Absorption Lidar. In the recently years, scientists have done much work on the development of such lasers. There’re many reports on continuous Tm:YAG laser. However, the study on Q-switched Tm:YAG laser, which is more useful in applications, was very rare. As the light source of Coherent Doppler Wind Lidar, large energy and wide pulse width is desired. Current reports mostly adopted CW pumped source, but it would make a mount of heat. Pulse pumping method could reduce the heat accumulation and improve the heat stability of the laser. How to improve the single pulse energy was the focus of current study. In this paper, a single end bonding Tm:YAG crystal with Tm<sup>3+</sup> doping concentration of 3.5at.% was used. Acousto-optic (AO) Q-switched (GOOCH and HOUSEGO QS041-10M-HI8) operation was adopted in our experiment. In the repetition frequency of 100Hz, a maximum single energy of 2.67 mJ (measured by Ophir 30A-BB) and the narrowest pulse width of 149 ns (measured by Vigo PCI-3TE-12 detector) were achieved at room temperature. The M<sup>2</sup><sub>x</sub> was 1.31 and the M<sup>2</sup><sub>y</sub> was 1.35 (measured by Spiricon Pyrocam-III). Tm:YAG laser was developed by using a pulse diode pumped L shape resonant cavity. The transmittance of the curve output mirror was 4% and the curvature radius of which was 300 mm. The output center wavelength of the laser was measured to be 2013.5 nm (measured by YOKOGAWA AQ6375).
266nm UV laser has a wide range of applications in many fields, such as laser medical treatment, laser processing,
precision measure and other applications for the reason of its advantages in wavelength, small diffraction effects, high single-photon energy, and high resolution and so on. BBO crystals absorb parts of the fundamental laser energy and second harmonic laser energy are unavoidable, and thus the temperature raise, so that the existing crystal phase matching conditions change, resulting in phase mismatching in the high-power frequency doubling, greatly influence the 266nm UV laser conversion efficiency. To further study the effect of phase mismatching to conversion efficiency, and improve the conversion efficiency, output power and other output characteristics of 266nm laser, the article mainly describe from the following three aspects. Firstly, took the use of three-dimensional nonlinear crystal temperature distribution which is obtained, the process of BBO crystal thermal-induced phase mismatching is analyzed. Secondly, based on frequency doubling theory, the effects of the thermal-induced phase mismatching affected of conversion in crystals are analyzed. Combining with the phase mismatching of the three-dimensional distributions, the fourth harmonic conversion efficiency with thermal phase mismatching changes of BBO 266nm UV laser are simulated for the first time. Thirdly, by using MATLAB software, the effects of phase mismatching to conversion efficiency in crystal for different waist radius, 532nm laser power and the fundamental beam quality are simulated. The results indicate a good physical interpretation of reasons of high power laser frequency doubling system. It shows that the model established explains the reason of the reduction of conversion efficiency, output power and the beam quality excellently. All results make a leading sense to the research on the compensating of the phase mismatching and on the improvement of conversion efficiency.