Paper
8 April 2010 Impact localization on complex structures using FBG strain amplitude information
Author Affiliations +
Abstract
Localization of low energy impacts on carbon fiber composites is an important aspect of structural health monitoring since it creates subsurface damage which can significantly reduce the stiffness of a component. A novel impact localization method is proposed based on the strain amplitude measured by Fiber Bragg Grating (FBG) sensors. The algorithm is based on the relative placement of all sensors and the maximum strain amplitude measured by each sensor. This method requires minimal knowledge of the material or the structure and a minimum number of sensors. The algorithm showed good results on both simulated and experimental test cases of woven composite plates. It was found that a minimum of five FBG are necessary to accurately predict the impact location on a plate. The algorithm was also tested on a woven composite wing showing good localization along the span of the wing but higher errors along the chord length due to the nonlinearity in the measured strains.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Cristobal Hiche, Clyde K. Coelho, Aditi Chattopadhyay, and Mark Seaver "Impact localization on complex structures using FBG strain amplitude information", Proc. SPIE 7649, Nondestructive Characterization for Composite Materials, Aerospace Engineering, Civil Infrastructure, and Homeland Security 2010, 764903 (8 April 2010); https://doi.org/10.1117/12.848872
Lens.org Logo
CITATIONS
Cited by 8 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Fiber Bragg gratings

Composites

Computer simulations

Algorithm development

Nondestructive evaluation

Structural health monitoring

Back to Top